Test And Install The Door/Window Contact; Overview; Test The Door/Window Contact - Smanos X300 Manuel D'utilisation

Test and Install the Door/Window Contact

The contact contains a transmitter and a magnet, which can be mounted on a door,
window, or any object that can be opened or closed. When the transmitter and
magnet are separated, the contact will send a signal to the control panel and the
control panel will trigger an alarm. The tamper switch ensures that sabotage attempts
to disassemble the contact will trigger an alarm.

Overview

LED Indicator
Transmitter
Front side
LED indication
Flash once: Intruder is detected.
Flash once per 3 seconds after triggered: Low battery. Replace the battery as soon as
possible.
PCB layout
Tamper Switch
15
Tamper Switch
Magnet
Back side
CR2032 Lithium Cell Battery
Note: When tamper switch is pressed,
system will alarm immediately.

Test the door/window contact

This is to test whether the contact can work properly.
Remove the insulating strip
The contact works immediately.
Pay attention to the direction
There are triangle marks on the
side of the transmitter and
magnet. Make sure the triangle
marks is close to each other and
within the range of 1 cm.
Test the door/window contact
Press the [Arm ] button. The system switches to the arm state. Separate the transmitter
and magnet with the space more than 2 cm. The red LED on the transmitter is on. Then,
the control panel triggers an alarm. This means the contact works properly.
1
EN
2
>2cm
16