Install The Pir Motion Detector - Smanos X300 Manuel D'utilisation

Install the PIR motion detector

After making sure the detector works normally, do as follows:
1. Choose a suitable installation location
For installation notices, please see page 23.
2m
2. Fix the detector
Fix the installation bracket on the wall with screws, and then fit the groove at the back
of the detector on the bracket. For the detector of this model, you can stick it at the
corner with double-sided tapes.
1
21
2
3. Test the PIR motion detector
Press the test button at the back. It switches to the testing mode and sustains for 3
minutes. Walk in the detection scope and observe the LED. When human movement is
detected, the LED flashes once.
4. Adjust the angle
Adjust the bracket angle to achieve the best detection effect.
Side view
EN
Top view
22