Overview; Power On And Network Setup - Smanos L020 Manuel D'utilisation

EN

Overview

Front
Rear
Battery
Side
App Pairing Button
Adapter Jack
Network Cable Jack

Power on and Network Setup

Status Indicator
Follow the illustrations above to connect the control panel with
power and router. Wait until the status indicator stops blinking
but keeps on, means it has connected with Internet.
Reset Button
Note:
cable is cut, when alarm occurs, the control panel hoots on site.
Installation:
central of the system or open area for optimal performance and
avoid load-bearing wall or home electronics which may cause
signal attenuation.
The control panel would not be able to control or push alarm
The control panel is suggested to be installed in the
EN