Delete Wireless Detectors; Delete Remote Controls; Switch To Testing Mode; Sms Alert For Low Battery - Smanos X300 Manuel D'utilisation

Delete wireless detectors

This is to disconnect detectors such as door/window contacts, PIR motion detectors
from the control panel.
1. Send "21"
Send the SMS "21" to the phone number of the control panel.
2. Delete wireless detectors
After the control panel receives the SMS, the status LED flashes quickly. The control
panel replies SMS to your smart phone with the content: Operate successfully.
Operate successfully.

Delete remote controls

This is to disconnect remote controls from the control panel.
1. Send "23"
Send the SMS "23" to the phone number of the control panel.
2. Delete remote controls
After the control panel receives the SMS, the status LED flashes quickly. The control
panel replies SMS to your smart phone with the content: Operate successfully.
Operate successfully.
39
21
23

Switch to testing mode

In testing mode, when accessories trigger alarms or tamper switch is triggered, the
control panel beeps for three times instead of sounding sirens. It will not send SMS to
or call users. It is recommended to enable the testing mode during testing and
installation.
1. Send "100"
Send the SMS "100" to the phone number of the control panel.
2. Enter testing mode
The status LED flashes quickly. The control panel enters testing mode. The control
panel replies with SMS indicating successful operation.
Operate successfully.
Note: The system exits the testing mode automatically in 10 minutes. Or press
control panel to exit .

SMS alert for low battery

SMS alert for low battery of the control panel
In case of AC power failure, the built-in 3.7V 1200mAh 18650 lithium battery can
sustain for 15 hours standby. When the battery is low, the control panel sends alert
SMS to the first alarm phone number automatically with the content: Panel Low
battery.
Panel Low battery.
100
"SOS" on the
EN
40