Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Settings
The keypad should enter setup state before all settings.
Enter Setup State
Input
[admin code]
+
[#]
①
Press
[3]
to enter setup state, the LED indicator is on.
②
Under setup state, if there is no operation within 10 seconds, the
keypad will exit setup state automatically. You can also press
exit.
9
to wake up keypad.
Exit Delay
The Exit Delay allows time to leave after arming the system. After
the delay time, if you are still at home, you may trigger an alarm.
This setting does not apply to Stay Mode.
If the delay time of both control panel and keypad are set
respectively, the actual delay time is the total of both.
Exit Delay
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for 10
seconds, the setup is successful.
Once the delay time is set, when you arm the keypad, it will beep
once every two seconds to remind you to leave. The reminding
rhythm will speed up in the last 15 seconds. After the delay time,
the control panel enters arm state.
[#]
to
Note:
User can input digital 0-250 which refers to 0-250 seconds. Default
setting: 0, no delay.
*2* delay time *
EN
10
Publicité
Chapitres
Table des Matières
