Working Principle; Testing; Test And Install The Control Panel; Overview - Smanos X300 Manuel D'utilisation

Working Principle

The control panel, core of the system, can be connected to different detectors. After
you install corresponding detectors in desired locations, if the intrusion is detected, a
detector sends a signal to the control panel, which generates audible alarm or sounds
sirens to deter intruders. Meanwhile, the control panel will send SMS to or call you via
the SIM card. Detectors, such as PIR detector, door/window contacts, vibration
detectors, smoke detector, gas leakage detector, water flood detector, work with the
control panel to shield your family and property.
sos
05

Testing

You need to test the control panel and accessories before installation. This is to ensure
the system works normally.

Test and Install the Control Panel

Overview

Front
LED indication:
Power LED/green
On: Normal power supply
Flashes once every second: Low voltage
Flashes 5 times every second:
No AC power supply
Status LED/red
On: Enter connect state
Flashes 5 times every second:
Recording, accessory triggering signals,
sending/receiving SMS, arm/disarm through
remote control
Flashes once every second: Alarming
Mode LED
Power LED
Status/Network LED
Bracket
Mode LED/blue
On : Arm
Flashes once every second:
Home mode
Off : Disarm
Network LED/blue
Flashes once every 1 second:
No SIM card or searching network
Flash once every 3 seconds:
Normal network
EN
06