Working Mode; Test The Pir Motion Detector - Smanos X300 Manuel D'utilisation

Working mode

Testing mode
After self-testing, press the test
button, the detector switches to
the testing mode and detects
once every 10 seconds. It triggers
an alarm. After 3 minutes, the
LED flashes twice, and the
detector switches to the power
saving mode.
Power Saving mode
The product features power-saving
design. If the detector detects human
movement twice in 3 minutes, it will
switch to the sleeping state to save
power. At this time, the LED will not
flash and no alarm. After no
movement within the next 3 minutes,
the detector switches back to the
working state automatically.
Note: After the detector is in the sleeping state, ensure no human movement within 3
minutes; otherwise, the detector remains sleeping.
In the sleeping state, it is recommended that you leave the room after arming the system.
Ensure no human movement in 3 minutes. Then, go into the room, the system alarms
immediately.
19
Case 1: Case 2: Press
Initial start the test button
and then arm. and then arm.
3 minutes later
Sleep after
detecting human
movement twice
No human movement
within 3 minutes
Switch from
sleep to arm.

Test the PIR motion detector

This is to test whether the PIR detector works normally.
1. Remove the insulating strip
Remove the insulating strip.
3. Trigger an alarm
Keep pressing the test button at the back until the control panel sounds. It indicates
that the PIR motion detector is connected to the control panel.
2. Arm the system
Press the [Arm ] button on the
remote control. The system is armed.
20
EN