Table des Matières
Publicité
Home mode(Part arm)
In home mode, detectors setting to
home zone are in disarm state; the other
detectors are still in arm state. That is,
you can move freely in the home zone;
however, the rest areas are still being
protected.
Press the
[Stay
]
button. 3 seconds
later, the control panel beeps once and
the mode LED is on.
Note:
The PIR detector is set to home zone by default. That is, the PIR detector will not trigger
an alarm after you press the
[Stay
]
button.
The zones include home zone, normal zone, 24-hour zone. For details of each zone, please
refer to page 56.
SOS
In case of emergency, you can press the
[SOS]
button.
Whenever you press the
[SOS]
button on
the remote control, the system will alarm
immediately. The control panel will send
SMS with the content "Emergency call" to
user and call the pre-stored phone
numbers.
13
Mute operation
You can arm and disarm the system silently.
Press the
[Stay
]
button for 1 second, and then press the
seconds. The system is armed silently.
Press the
[Stay
]
button for 1 second, and then press the
3 seconds. The system is disarmed silently.
Note:
If wireless strobe sirens are used, they will not sound either.
EN
[Arm
]
button within 3
[Disarm
]
button within
14
Publicité
Chapitres
Table des Matières
