Final Checks; User Instruction - Erreka FENIX Manuel De L'utilisateur

STARTING UP AND PROGRAMMING
Slowdown distance (
1 Keep the |+ button pressed down until the display
P
shows .
2 Release the button |+ : the display will show
3 Press the button |+ until the display shows
press SET to confirm.

The display shows 3 (predetermined value).
Fixed code (trinary) or roller code transmitter (
1 Keep the |+ button pressed down until the display
P
shows .
2 Release the button |+ : the display will show
3 Press the button |+ until the display shows
press SET to confirm.

The display shows 6
6

FINAL CHECKS

Following installation and programming, start up the
operator and check the devices installed.
1 Check the correct operation of the key commands
(push button and wall key, remote control).

See "Operation modes" on page 50.
2 Check the correct operation of the safety devices
(photocells).

See "A- Detection by the additional safety device
(photocell)" on page 51.
3 Place an obstacle and make the door collide with it
in order to check operation in the event of collision.

See "B- Direct detection (sensitiveness of the
actuator)" on page 51.

If the system does not work correctly, find out
why and put it right (see section "Failure
diagnosis" on page 65).
64
Installation Manual
5
)
1
.
5
and
1
.
6
and
).
(flashing
4 Press |+ and |- to select the required value:

1: without slowdown

2: slowdown, distance 20mm (measured in the
track

3: slowdown, distance 100mm (measured in the
track

4: slowdown, distance 250mm (measured in the
track)
5 Press SET to confirm.

The display will flash
will show H or h (programming mode complete).
6
)
4 Press |+ and |- to select the required value:

F: trinary, fixed code

r: standard roller code

r.: personalised roller code
5 Wait for 1 second.

The display will flash
will show H or h (programming mode complete).

User instruction

1 Instruct the user with regards to the use and
maintenance of the installation and provide him/her
with the instructions on use.
2 Signpost the door, showing that it opens
automatically and indicating how to operate it
manually. Where appropriate,
operation is using the remote control.
5
and after a few instants
6
and after a few instants
indicate that