Installation; Required Tools; Required Materials; Initial Conditions And Checks - Erreka MAGIC MA210 Manuel De L'installateur

INSTALLATION

1

REQUIRED TOOLS

Set of screwdrivers
Fixed wrenches (13 mm and 17 mm)
Allen key (5mm)
Marker pencil
Spirit level
2

REQUIRED MATERIALS

Screws for attachment to the base plate and the wall
angle
3

INITIAL CONDITIONS AND CHECKS

Initial conditions of the door

Check that the size of the door is within the
admissible range of the operator (see the
technical characteristics of the operator).

If the door to be automated has a pedestrian
door, use a safety device to prevent the
operator from operating with the pedestrian
door open.

The door must have a closing stopper.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

The electrical connections shall be made in line
with the instructions in the control board
manual.
48
Installation Manual
Tape measure
Electrical drill and broaches

Use the electrical drill in line with the user
instructions.
Lubrication grease (graphite or lithium grease).

The door must be easy to handle manually, namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its open/
close.

Do not install the operator in a door which
does not work correctly in manual operation,
as this may lead to accidents. Repair the door
before installing.

Check that the admissible environmental
temperature range for the operator is suitable
for the location.

The electrical wire section is indicated in: "Fig. 1
Elements of the complete installation" on page 43.