Installation; Necessary Tools; Necessary Materials; Initial Conditions And Checks - Erreka FENIX Manuel De L'utilisateur

INSTALLATION

1

NECESSARY TOOLS

Flathead screwdriver 0.6 x 3.5
Spanner 10mm
Ring spanner 10mm
Socket wrench 10mm
Marker pencil
Level
Tape measure
2

NECESSARY MATERIALS

Screws to attach the strips to the ceiling, the front
support to the wall and the door anchoring to the door.
3

INITIAL CONDITIONS AND CHECKS

Door operation

The door must be easy to manipulate manually, namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its travel.
Do not install the actuator in a door which does not
work correctly in manual operation, as this may lead
to accidents. Repair the door before installing.
Saw for cutting metal
Electric drill and broaches

Use the electrical drill in line with the use
instructions.
Ladder

Use a robust ladder of sufficient height.
Respect the instructions on use.
Track lubrication grease (graphite or lithium grease)
Electrical power supply installation
The actuator has a power cable with a plug. There
should be an earthed current connection close by.

Ensure the current connection and installation
fulfil the following requirements:
• The nominal voltage of the installation must
coincide with that of the actuator.
English
53
FENIX Overhead Actuator