INSTALLATION
Position the overhead strips
Attach the track to the motor
56
Installation Manual
1 Choose screws which are suitable for the place of
attachment (metal, brick, wood, etc) and the weight
and effort of the actuator.
Use appropriate screws.
2 Make the holes in the marked points.
3 If necessary, cut the strips.
4 Attach the strips.
O
Ensure that the chain is correctly positioned in the
track and mounted on the cog for correct operation.
1 Position the stretched coupling (1) on the actuator
shaft (2).
2 Fit the cog (3) of the track (4) in the stretched
coupling (1)
3 Position the flanges (5).
4 Position the four M6 screws with their four washers
and tighten them.
Use the 10mm socket wrench.