Erreka FENIX Manuel De L'utilisateur page 67

Maximum thrust in opening (
1 Keep the |+ button pressed down until the display
P
shows .
2 Release the button |+ : the display will show
3 Press the SET button to confirm.

The display shows 4 (predetermined value).
4 Press |+ or |- as many times as necessary to add or
remove levels until the required thrust level in
opening is reached.

1: minimum thrust

8: maximum thrust
Maximum thrust in closing (
1 Keep the |+ button pressed down until the display
P
shows .
2 Release the button |+ : the display will show
3 Press the button |+ until the display shows
press SET to confirm.

The display shows 4 (predetermined value).
4 Press |+ or |- as many times as necessary to add or
remove levels until the required thrust level in
closing is reached.

1: minimum thrust

8: maximum thrust
Functioning mode (automatic, step-by-step, standby time) (
1 Keep the |+ button pressed down until the display
P
shows .
2 Release the button |+ : the display will show
3 Press the button |+ until the display shows
press SET to confirm.
4 Press |+ and |- to select the required value:

1: Automatic mode, standby time: 30 sec

2: Automatic mode, standby time: 45 sec

3: Automatic mode, standby time: 1 min
Precise adjustment of the lower limit (
1 Keep the |+ button pressed down until the display
P
shows .
2 Release the button |+ : the display will show
3 Press the button |+ until the display shows
press SET to confirm.

The display shows N.
1
)
1
.
5 Press SET to confirm.
2
)
1
.
2
and
5 Press SET to confirm.
O
1
.
3
and
5 Press SET to confirm.
4
)
4 Keep the |+ or |- button pressed down to open or
1
.
5 Press SET to confirm.
4
and
STARTING UP AND PROGRAMMING

Adjust this parameter to the lowest
possible value compatible with the correct
operation of the installation. In this way the
operator has greater sensitiveness to detect a
possible collision of the door with an obstacle
(see "Behaviour in the face of an obstacle" on
page 51).

1
The display will flash
will show H or h (programming mode complete).

Adjust this parameter to the lowest
possible value compatible with the correct
operation of the installation. In this way the
operator has greater sensitiveness to detect a
possible collision of the door with an obstacle
(see "Behaviour in the face of an obstacle" on
page 51).

2
The display will flash
will show H or h (programming mode complete).
It is necessary to precisely adjust the lower limit
whenever the maximum closing thrust is modified.
3
)

4: Automatic mode, standby time: 2 min

5: Automatic mode, standby time: 3 min

6: Automatic mode, standby time: 4 min

7: Automatic mode, standby time: 5 min

8: Automatic mode, standby time: 6 min

N: Step-by-step mode

3
The display will flash
will show H or h (programming mode complete).
close the door respectively, until the exact position
to be programmed as a lower limit is reached.

4
The display will flash
will show H or h (programming mode complete).
FENIX Garage door opener operator
and after a few instants
and after a few instants
and after a few instants
and after a few instants
63