Malfunction Table - Dibo PTL Serie Mode D'emploi

7. Malfunction table

At a possible malfunction one can consult the table mentioned below and if you obtain on this basis no solution, we
advise to contact a DiBO technician and/or a recognized DiBO representative.
Malfunction
Machine does not start
No water pressure
Instable and to weak pressure
HP pump pulse
Cause
Battery tension too low
Operation switch "OFF"
Start engine does not work
Too few oil in engine casing
Rest malfunctions
To few water inlet
Filter stuffed-up
Air in water supply (leaks in water
supply)
Nozzle or lance stuffed-up or worn-
out.
Pressure regulator defect
Rest malfunctions
Leak or congestion in supply conduit
To much air present
DiBO n.v. 67
Solution
Loads battery
Operation switch "ON"
Consult an expert
Refill oil
Consult an expert
Repair water inlet
Clean/replace filter cartridge
Put machine completely without
power! Repair leaks in supply.
Clean or replace
Consult an expert
Consult an expert
Clean/replace/repair
De-aeration of cleaner