Operation; Start With Petrol Motor - Dibo PTL Serie Mode D'emploi

4. Operation

4.1. Start with petrol motor

1. Choke handle
The choke is situated under the protection cover of the engine.
The choke has 2 positions:
Not choking (working position, handle up to right stop)
Choking (handle up to the left)
Warm start/ warm environment:
Do not choke.
Choke handle stays to the right stop.
Cold start:
Choke according to the needs.
Engine runs warm.
Move the choke handle to the right, as the engine gets warmer.
2. Fuel tap
The fuel tap is situated under the protection cover of the engine.
The fuel tap has two positions:
OFF = no fuel ( tap to the left) with gas engine close down.
ON = fuel (tap to the right) with gas engine in operation.
3. Gas handle
The gas handle is situated under the protection cover of the engine.
The gas handle can only be applied in two positions:
0 = stationary number of revolutions (heating, cooling, short break)
1 = full gas during cleaning works
Remark: Use the gas handle NEVER to arrange the spray pressure.
Starting and warming up:
Move the gas handle a little bit open to the left.
Move the gas handle a little bit to the FAST-position (high-speed position) and make sure that the fuel tap is on
position ON. Start the engine, electric or with the traction cord, depending the model.
Hold the handle in this position, so that the engine can run warm idle at lower revolutions.
Engine is at operating temperature:
Push aside the gas handle to the left (against the stop = the maximum position), till the desired number of revolu-
tions of the engine is regulated.
DiBO n.v. 58
Gas handle
Choke handle
Fuel tap