Working Switch: With Hand Started Engine; Working Switch: With Electric Started Engine - Dibo PTL Serie Mode D'emploi

Switching off the engine:
Push aside the gas handle completely to the right, position MIN, up to the right stop.
Let the engine run at stationary revolutions for a while to cool down.
Put the working switch on position 0 (=out) and the fuel tap on OFF.

4.2. Working switch: with hand started engine

The working switch is situated along the front of the protection cover under the gas tank of the engine.
The working switch has two positions:
0 : OFF = out
1 : ON = working position

4.3. Working switch: with electric started engine

The working switch can be situated at the front or at the side of the protection cover.
The working switch has 3 positions and is operated with a key:
0 : OFF = out, stop
1 : ON = in working position
START: = starting the engine.
The engine switch needs to be turned to 'START', one must hold these there (no longer then 5 sec) to the engine
starts. If the engine does not start, wait 10 seconds, before trying again.
Afterwards, turn again to 1: ON.
A circuit breaker protects the electric battery charge circuit, at disturbances (no oil) or bugs. A switched off circuit
(green indicator out) could be activated again by pushing this button after repairing the disturbance.
DiBO n.v. 59