Pull Rope; Pressure Regulator; Spraying Tools - Dibo PTL Serie Mode D'emploi

4.4. Pull rope

Put the working switch of the engine in the ON position.
The traction cord is mounted with a handle, which has to pull out calm till there can be sensed a resistance.
The freewheel clutch is now entered. Next, the cord has to be pulled out in a strong move to start the engine.
After each start (- attempt) you have to spring back the pulled cord easily.
After long-time standstill or first operation, operate motor with low adjusted speed and without load for
approx. 20 sec. after start.
Never let turn the motor without an air filter, since these lead to a quickly wear of the motor.

4.5. Pressure regulator

The pressure regulator is mounted at the left of the machine.
On the pressure regulator sits a turning button, with which the spray pressure can be established continues.
Turning the button to the right is a higher pressure.
Turning the button to left is a lower pressure.
The pressure can only be adjusted if the spray gun is operated.
The spray pressure is indicated on the manometer.

4.6. Spraying tools

The high pressure hose must be coupled turnable to the spray gun.
Mount (tighten) also the spray lance to the spray gun.
The high pressure spray gun has been carried out with a grey handle.
No spraying: release the lever in the handle.
Spraying: pressing the lever in the handle.
Spray security: slap the block-system out in the lever.
The machine is standard provides with two single spray lances.
At use of reel(s) (optionally): always unroll the reel hose(s) completely during spraying activities to ensure an opti-
mal performance!
Checks during praying regularly or the lance coupling still sits firmly on the gun.
Block system
DiBO n.v. 60