Selve SE Plus-R Notice D'utilisation page 23

Contents
Dear Customer,
by purchasing a SELVE electronic radio drive you have decided in favour of a quality
product from the SELVE company. This instruction manual describes the installation
and operation of the drive. Make sure to read this handbook before commissioning of
the SELVE drive and adhere to the safety instructions.
After publication of the operating instructions, SELVE shall not be liable for any changes
to norms and standards! Subject to change without prior notice!
1. Safety instructions ............................................................................................ 24
2. Information about the drive features .............................................................. 25
2.1. Designated use ........................................................................................... 25
2.2. Drive type features ..................................................................................... 25
2.3. SELVE radio special features .................................................................... 26
3. Installation and electrical connection ............................................................. 26
3.1. Installation of the drive into a shaft .......................................................... 26
3.2. Supporting the motors .............................................................................. 27
3.3. Assembly and disassembly of the patch cord ......................................... 28
3.4. Electric connection .................................................................................... 28
4. Setting of the end positions ............................................................................. 29
4.1. Delivery status ............................................................................................ 29
4.2. Setup functions .......................................................................................... 29
4.3. Mechanic requirements ............................................................................. 30
4.4. Selection table for settings ....................................................................... 30
4.4.1. Automatic setup-mode for SEL Plus-R and SES-R ....................... 31
4.4.2. Manual setup-mode for SE Plus-R, SEL Plus-R and SES-R ......... 32
4.4.3. Manual setup-mode for SE Plus-R, SEM Plus-R
SEL Plus-R and SES-R .................................................................... 33
4.4.4. Manual setup-mode for SEM Plus-R ............................................. 34
5. Teaching in/deleting of other transmitters/channels ..................................... 35
5.1. Programming of further transmitters/channels ...................................... 35
5.2. Deleting of transmitters/channels ............................................................ 35
6. Set intermediate position ................................................................................. 35
7. Adjusting the end position with the setting switch ........................................ 36
8. Functions in service mode (setting by using a transmitter) .......................... 37
8.1. Adjusting the end limits by using the transmitter .................................... 37
8.2. Reprogramming if a transmitter is damaged or lost ............................... 38
8.3. Resetting to the delivery status ................................................................ 38
8.4. Group separation ....................................................................................... 39
9. Technical data ................................................................................................... 40
10. General declaration of conformity .................................................................. 40
11. Troubleshooting ................................................................................................ 41
12. Notes .................................................................................................................. 42
23
GB