Iii- Location Of "S" And "+" Keys; Default Configuration - Bodet NTP/WIFI Notice D'installation

III – Location of "S" and "+" Keys
1) These two keys are located on the back of the clock:
– Right side: when viewed from the back
– Left side: when viewed from the front (when being handled)
2) The "S" key is above the "+" key.
3) When pressed, an LED lights up to indicate the selected key.
Examples (Style 7D & Style 10SD) showing the two keys pressed simultaneously:
IV

– Default Configuration

To restore factory settings, press the red button
Open the clock to access this button (see Installation).
Location of Factory Config button on the electronic board:
The full factory configuration is as follows:
• IP configuration by DHCP (DHCP: ON)
• Time zone: EUR
• Synchronisation: Multicast
• Synchronisation address: 239.192.54.1
• Clock name: BODET-@MAC
• Poll period for unicast synchronisation: 15 mins.
• SNMP disabled
• Trap type: V2C
• Temperature alarm threshold: -5°C to +55°C
• Trap status issue period: 24 hrs
• No password for embedded web server access
• Luminosity: level 3 for Style 5, 5S, 7, 7D, 7E and 7S
• level 4 for Style 10, 10S, 10D and 10SD
• 12 hr/24 hr mode: 24hr
• Synchronisation mode: NTP
• Eco mode: Nor
• Accsess Point mode activated in Open mode pending a password to switch to WPA2 mode.
10
A on the electronic board until the clock turns black.
A
EN
S
+