Principle Of Time Setting; Afnor Receiver Model; Dhf Clock - Bodet Cristalys 7 Instructions De Mise En Service Et D'utilisation

VI - PRINCIPLE OF TIME SETTING

6.1 Afnor receiver model

1.
On the initial powering up, the time is initialised at 00h00mn00ss on 01/01/2000.
After a powering up, a time setting, a reset or a new configuration, the clock search to be
synchronised. Since 3 consecutives correct messages have been received, it set up its
time base to the correct time. After, it is automatically done each hour.
Between 2 synchronisation, the time base bring forward according to the internal base.
If the clock is in mode COD
If the clock is in mode LOC
Time mode menu (Seasonal change and offset change).
Caution: if the current time of the master clock is modified after the synchronisation of the
slave clocks, the correction will be achieved the next hour.
2.
If the synchronisation is not correct after 20 seconds, a new time code search is made the
following minute.
If the synchronisation is not correct after 24 hours, the clock pictogram will flash every 5
seconds, the display disappeared with only the 2 dots fixed.
If the AFNOR synchronisation is not correct after 1 hour, the clock pictogram flashes
every second and the clock keeps on working on its own time basis.
In AFNOR mode, if the synchronisation is not correct after 24 hours, the clock pictogram
flashes every 5 seconds and the display disappears with only the 2 dots fixed.
In AFNORI mode, if the synchronisation is not correct after 24 hours, the clock keeps on
working on its own time basis with the 2 dots fixed.
Nota :
On an Irig-B network, year must be manually entered by the user.

6.2 DHF clock

On leaving
the factory, the DHF clock is set in "Initialisation" mode. After inserting the
batteries, the clock displays INIT for 5 seconds then 00:00.
The synchronisation search is limited to 4 hours. Beyond, the clock stops searching and
displays only 2 fixed dots. A press on one of the keys will restart the synchronisation
search for 4 hours.
It memorises the address of the transmitter and switches to normal mode automatically
when time is received.
In case of interference or absence of signal:
In DHF mode, if the synchronisation is not correct after 24 hours, the clock pictogram
flashes every 5 seconds and the display disappears with only the 2 dots fixed.
In DHFI mode, if the synchronisation is not correct after 24 hours, the clock keeps on
working on its own time basis with the 2 dots fixed.
If needed (change of communication channel, new installation...), the clock can be
switched to "Initialisation" mode in the technician menu.
14See the technician menu page 32.
15See the Time mode menu page 27
30
14
, the time displayed is the time received.
15
, the time displayed depend on the offset selected in the