Installation In Harness Mode - Britax GROW WITH YOU Guide D'utilisation

BRITAX Child Safety, Inc.

Installation in Harness Mode

Harness Mode: Lap-Shoulder Belt
Before you begin:
•
•
•
1� Pull seat cover forward�
2� Pull the vehicle belt
3� Push the child seat
4� Firmly press the tether hook over a designated vehicle
10
12390000_USER GUIDE_GROW WITH YOU, CAN.indb 10 12390000_USER GUIDE_GROW WITH YOU, CAN.indb 10
Check that your vehicle has a top tether anchor�
The top tether must be used at all times when
installing the child seat in harness mode� Using the
top tether will improve the stability of your child seat
and reduce the risk of injury� Check your vehicle
owner's manual for tether anchor locations�
Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during installation�
Adjust the child seat to desired position and place
forward facing on the vehicle seat�
out and route along
the green belt path�
Verify that the belt is
not twisted and then
buckle�
firmly into the vehicle
seat while removing all
slack from the lap part
(A) and the shoulder
part (B) of the vehicle
belt�
NOTE: Ensure that the vehicle belt is locked as directed
by your vehicle owner's manual.
NOTE: The child seat is secure when it cannot be
moved front-to-back or side-to-side more than 2.5 cm
(1 in.) at the belt path. If the child seat is not secure,
repeat the installation procedure or use a different
seating location.
tether anchor� Remove slack�
2/12/2020 6:20:04 PM 2/12/2020 6:20:04 PM