Britax GROW WITH YOU Guide D'utilisation page 14

BRITAX Child Safety, Inc.
Harness Mode: LUAS
Before you begin:
•
•
•
•
1� Pull seat cover and seat
2� Route the lower
3� Push the child seat
12
12390000_USER GUIDE_GROW WITH YOU, CAN.indb 12 12390000_USER GUIDE_GROW WITH YOU, CAN.indb 12
Check that your vehicle has lower anchors�
Use the vehicle belt (not lower connectors) for
harness mode installations with children who weigh
more than 20�4 kg (45 lbs)�
Check that your vehicle has a top tether anchor�
The top tether must be used at all times when
installing the child seat� Using the top tether will
improve the stability of your child seat and reduce
the risk of injury� Check your vehicle owner's
manual for tether anchor locations�
Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during installation�
Adjust the child seat to desired position and place
forward facing on the vehicle seat�
pan forward to access
the lower connectors�
connector strap along
the green belt path
behind the seat pan and
firmly press the lower
connectors onto their
adjacent lower anchors�
NOTE: Verify that the
strap is not twisted.
firmly into the vehicle
seat while removing any
slack from the lower
connector strap to
remove slack�
NOTE: The child seat
is secure when it cannot be moved front-to-back or
side-to-side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the installation
procedure or use a different seating location.
2/12/2020 6:20:33 PM 2/12/2020 6:20:33 PM