In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised high
enough to properly adjust the harness
for the fit of your child� DO NOT force
the child seat head restraint past the
vehicle head restraint� Doing so could
cause the child seat not to perform as intended� If the
location of the vehicle head restraint interferes with the
child seat head restraint, raise or remove the vehicle head
restraint� If the vehicle head restraint cannot be removed,
move the child seat to the upright position or try a
different seating location�
Overhang
Harness Mode
It is important that the base of
the child seat rests completely
flat on the vehicle seat with no
side overhang� As seen in the
illustration, it is permissible to
allow up to 7�6 cm (3 in�) of the
base to hang over the front edge
of the vehicle seat� If the vehicle
seat does not allow enough of the
child seat base to make contact,
adjust the recline angle to a more
upright position� Not doing so
could cause the child seat to not
perform as intended�
Booster Mode
IMPORTANT:
In booster mode, the base of the child seat must fit
completely on the vehicle seat�
Adjusting Buckle Position
Removing the Buckle
1� Unbuckle the harness
12390000_USER GUIDE_GROW WITH YOU, CAN.indb 23
12390000_USER GUIDE_GROW WITH YOU, CAN.indb 23
Overhang is not allowed in booster mode�
by pressing the release
button and pulling the
tongues�
GROW WITH YOU User Guide
WARNING!
WARNING!
7�6cm
Harness Mode
23
2/12/2020 6:21:33 PM
2/12/2020 6:21:33 PM