Monitoring Transmission Status From Leds Placed On The Control Lever - SICE S 60 Manuel D'utilisation

Pedals with central rest position (G fig. 14a)
Activate the pedal to start turntable
spindle clockwise/counter clockwise
rotation.
Pressing RH pedal the turntable will
rotate clockwise. Release the pedal to
stop rotation.
Pressing LH pedal the turntable will rotate
counter clockwise. Release the pedal to
stop rotation.
14a
Stop BUTTON (H fig. 14b)
Press the stop button to stop all machine
signals that are transmitted by the control
lever. The button stops the communication
both in radio transmission mode and cable
transmission mode.
To restore the controls simply reset the
stop button. Wait for a few seconds for the
automatic restoring of the signal commu-
nication before giving any other command.
14b
MONITORING TRANSMISSION STATUS
FROM LEDS PLACED ON THE CONTROL
LEVER
UK
YELLOW LED - LOW BATTERY
This LED turns on when the voltage of the power supply battery, of the radio transmis-
sion, is below the minimum operating voltage. Recharge the batteries.
GREEN LED - TX ON
This LED turns on to indicate active data
transmission between the transmitter and
receiver units.
RED LED - TX OFF
This LED turns on to indicate negative data
transmission between the transmitter and
14c
receiver units.
User Manual S60 79