Installation On The Tyre Changer - SICE PT 230 E Manuel D'instructions

WaRnInG
Do not remove or deface the safety Danger, War-
ning or Instruction decals. Replace any missing
or illegible decals. Missing or damaged decals can
be obtained at your nearest dealer.
- When using and carrying out maintenance on the
machine observe the unified industrial accident
prevention regulations for high voltage industrial
equipment.
- Any unauthorised alterations made to the machine
automatically release the manufacturer from any
liability in the case of damage or accidents attri-
butable to such alterations. Specifically, tampering
with or removing the machine's safety devices is
a breach of the regulations for industrial accident
prevention.
WaRnInG
When operating or servicing do not wear ties, loose
fitting clothes, necklaces, rings or wristwatches
that could become entrapped by moving parts.
InsTallaTIon on THE
TYRE CHanGER
• Disconnect the machine from the mains fig.1
and compressed air line fig. 2.
• Disconnect the air hoses T of the filter-regulator
unit on the rear right of the casing and remove
the unit fig. 2 and the grease cone support
22
• Remove the side cover fig. 3;
• Remove the guard from the base of the column,
fig. 3;
• Install the riser F on the tire changer
• Secure it to the tire itself, using the screws
provided in the kit, the points shown in the
figure (fig. 4)
1. insert the screw and the nut and the washer G;
2. insert the screw and washer A
1
3. mount the bracket on the side bead H beam
with the screws I, Block L and nuts M
4. Replace the filter assembly with the screws B
• Install the power unit on the mast fixing it
with the screws provided, in the points shown
in fig. 5:
PT 230 E - Operator's manual + spare parts
T
2
3