System Reset - Abus Terxon SX AZ4301 Manuel D'installation

031 Zone tamper
Proceed as follows to change the property of zone
tampering:
1. On the control unit, enter:
UK
2. The LCD display shows: 031:EngTmpRstOFF
3. Via the keypad, select from the following items
and press:
0
1
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.

033 System Reset

To change the property of the system reset:
1. On the control unit, enter:
2. The LCD display shows: 033: EngReset OFF
3. Via the keypad, select from the following items
and press:
0
1
Note:
031
EngTmpRstOFF
No program code necessary (OFF).
If a tamper alarm is triggered, you only
have to enter the user code to
acknowledge the tamper message.
EngTmpRstON
Program code required (ON)
If a tamper alarm is triggered, you have
to enter the user code to deactivate the
alarm and then the program code to
delete the tamper alarm.
033
EngReset OFF
If a system error is displayed, you only
have to enter the user code to
acknowledge the message.
EngReset OFF
If a system error is displayed, you have
to enter the program code to
acknowledge the message.
Some events always require you to enter the program
code. These are:
Failure/fault of a control unit
Failure of 12V power supply
Low battery in the alarm centre
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
034 Panic Reset
Proceed as follows to change the property of the panic
reset:
1. On the control unit, enter:
2. The LCD display shows: 034:PA Cust Rst
3. Via the keypad, select from the following items
and press:
PA Cust Rst
0
To reset a panic alarm, you only have
to enter a valid user code.
PA Eng Rst
To reset a panic alarm, you have to
1
enter the user code to deactivate the
alarm and then the program code to
delete the panic alarm.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
44
034