Abus Terxon SX AZ4301 Manuel D'installation page 118

022 Changing the volume for internal alarm
For changing the zone termination for the inputs of the
burglar alarm centre. From the program level, do the
following:
1. On the control unit, enter:
UK
2. The LCD display shows: 022:ChimeVol=5
3. Via the keypad, select from the following items
and press:
0-9
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
025 Internal alarm
To change the property of the internal alarm:
1. On the control unit, enter:
2. The LCD display shows: 025:LS Timed
3. Via the keypad, select from the following items
and press:
0
1
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
022
ChimeVol
Specify the volume of the internal alarm
issued via the control unit and the
(optional) loudspeaker.
Press:
0 off
1 quiet
9 loud
025
LS Timed
The internal alarm follows the entered
times for the external siren
LS Cont
The internal alarm sounds until the
alarm centre is deactivated.
027 Alarm on failed activation
To change the property of the alarm on failed activation,
proceed as follows:
1. On the control unit, enter:
2. The LCD display shows: 027:Internal
3. Via the keypad, select from the following items
and press:
Internal
0
If activation fails, the alarm is issued via
the internal signaller.
Local
1
If activation fails, the alarm is also
issued via the external siren.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
42
027