Abus Terxon SX AZ4301 Manuel D'installation page 126

062 Behaviour of exist mode internal active
(B)
To change the property of the exit mode for internal active
(B):
1. On the control unit, enter:
UK
2. The LCD display shows: 062: B=LEISE
3. Via the keypad, select from the following items
and press:
0
1
2
3
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
063 Alarm behaviour for internal active (B)
To change the alarm property for internal active (B):
1. On the control unit, enter:
2. The LCD display shows: 063: B=Keypad
3. Via the keypad, select from the following items
and press:
0
1
062
Low Tone
The acoustic signal during the exit
delay time is emitted at half volume.
Instant
During internal activation, the alarm
centre is internally activated
immediately – i.e., without delay.
Silent
No acoustic signal is emitted during the
delay time. Following expiry of the delay
time, the alarm centre emits a brief
signal.
B=A
The initial mode for internal active B is
as for the initial mode of overall active A
063
B=Keypad
Only the control units are activated.
B=Internal
On alarm, the control units and the
internal alarm are activated.
B=Local
On alarm, the control units, the internal
2
alarm and the external siren are
activated.
B=Full
On alarm, the control units, the internal
3
signalling, the external sirens and the
telephone dialler are activated.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
065 Exit delay time internal B
To change the property of the exit delay time for internal
active B:
1. On the control unit, enter:
2. The LCD display shows: 065: Exit B=20
3. Via the keypad, select from the following items
and press:
Exit B=10
1
Exit delay time for internal active B is 10
seconds.
Exit B=20
2
Exit delay time for internal active B is 20
seconds.
Exit B=30
3
Exit delay time for internal active B is 30
seconds.
Exit B=45
4
Exit delay time for internal active B is 45
seconds.
Exit B=60
5
Exit delay time for internal active B is 60
seconds.
Exit B=120
6
Exit delay time for internal active B is
120 seconds.
4. Confirm your input. On the control unit, enter:
.
50
065