Silencing The Alarm - Sime ECOMAXI 260 ErP Manuel D'installation, D'utilisation Et D'entretien

Installation, use and maintenance manual
 Press and release the
 Press and release the
button within 15 seconds to select
"1" (first ON/OFF time) or "2" (second
ON/OFF time);
 Press and release the
not touch the display for 15 seconds;
To exit the procedure before completion:
 Do not touch the display for 15 seconds
(any changes are saved) or press and
release the button.
Carefully consider any activation
of the automatic ON/OFF time
settings so as to avoid causing a
disservice to the users.
7.1.3.7 Displaying the operating status
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no
other advanced procedures running;
 Press and release the
code corresponding to the current
active operating mode is displayed for 3
seconds (Auto/ECO/Obst/Anti).
7.1.3.8

Silencing the alarm

To silence the alarm, do as follows:
 Ensure that there is no other advanced
procedure running;
 Press any button once.
NOTE: the instructions below are
for specialist technical support
personnel.
64
button;
button or the
button or do
button: the
DOCUMENT 6328408
7.1.3.9 Conditions for starting the different
operating modes
Each operating mode must respect specific
conditions in order to be activated:
 AUTOMATIC mode
The condition for starting up this function
is as follows: lower probe < SP2 – r0
(hysteresis);
 ECO mode
The condition for starting up this function
is as follows: lower probe < SP1 – r0
(hysteresis);
 OVERBOOST mode
The condition for starting up this function
is as follows: lower probe < SP3 and
upper probe < SP3.Once a temperature
above SP3 has
Overboost mode
appliance returns
mode previously set.
7.1.3.10 Display
If the appliance is ON, during normal
operation the temperature detected via
parameter P5 is shown on the display:
 If P5 = 0, the temperature of the upper
part of the boiler is displayed;
 If P5 = 1, the active operating setpoint is
displayed;
 If P5 = 2, the temperature of the lower
part of the boiler is displayed;
 If P5 = 3, the evaporator temperature is
displayed;
 If the appliance is in stand-by mode, the
display is off.
been detected,
stops and the
to the operating