Buttons And Interface Display - Sime ECOMAXI 260 ErP Manuel D'installation, D'utilisation Et D'entretien

Installation, use and maintenance manual
SET On/Stand-by
button button
Fig. 16 – User interface
7.1.1

Buttons and interface display

7.1.1.1 On/Stand-by button
Use this button to:
 turn the product on (ON status);
 put the product in stand-by mode (in this
mode, the appliance can operate
automatically according to specific time
settings and automatically activate the
anti-legionella and defrosting functions).
When the appliance is powered
up, it keeps the same status as
when the power supply was
disconnected.
7.1.1.2 [SET] button
Use this button to:
 confirm a selection or value set.
7.1.1.3 [UP] button
Use this button to:
 scroll up through the list of parameters;
 increase the value of a parameter.
7.1.1.4 7.1.1.4 [DOWN] button
Use this button to:
 scroll down through
parameters;
 decrease the value of a parameter.
7.1.1.5 Interface display
The interface display (Fig. 17) shows the:
60
Display
DOWN UP
button button
the list of
DOCUMENT 6328408
 control temperature;
 alarm/error codes;
 status notifications;
 operating parameters.
Fig. 17 – User interface display
Compressor LED
Defrosting LED
MF LED
Fan LED
Maintenance
LED
Alarm LED
Degrees Celsius
LED
LED
Degrees
Fahrenheit
LED
On/stand-by
If it is on: the compressor is
active.
If it is flashing:
 The compressor is in the
process of switching on;
 The operating setpoint
is being modified
If it is on: defrosting is in
progress
If it is on: the electrical
resistor on the boiler is active
If it is on: the fan is active
If is on: the air filter requires
maintenance (if present)
If it is on: check the list of
alarms and follow the
procedure indicated in this
manual
If it is on: the unit of
measurement for
temperature is degrees
Celsius
If it is on: the unit of
measurement for
temperature is degrees
Fahrenheit.
If it is on: the device is in
stand-by mode.
If it is flashing: the appliance
has been switched on/off
manually while in automatic
timed on/off mode
Not used