Sime ECOMAXI 260 ErP Manuel D'installation, D'utilisation Et D'entretien page 65

7.1.3.11 Alarms
Note: for alarm "UtL" (faulty fan),
in addition to the message on the
display, the appliance also emits
a sound alarm, which can be
silenced by pressing any button
on the controller. The alarm does
not disappear, unless you turn
the appliance off or set it to
standby mode.
Operation via the heat pump is
automatically disabled and the
resistor enabled, to guarantee a
continuous supply of hot water.
NOTE: If you see the "UtL" alarm,
you must contact the support
service
Installation, use and maintenance manual
AL Minimum temperature alarm
Solutions:
- Check the temperature associated with
the alarm;
- See parameters: A0, A1, A2 and A11.
Main consequences:
- The appliance continues to function
normally
AH Maximum temperature alarm
Solutions:
- Check the temperature associated with
the alarm;
- See parameters: A3, A4, A5 and A11.
Main consequences:
- The appliance continues to function
normally
id Digital input alarm
Solutions:
- Check the cause of the alarm (signal
cables short-circuited)
- See parameters: i0, i1 and i2;
Main consequences:
- The compressor is switched off;
- Defrosting is not activated
iSd Appliance locked alarm
Solutions:
- Check the cause of the digital input
alarm
- See parameters: i0, i1; 18 and i9
- Turn the appliance off and then on again,
or disconnect the power supply
Main consequences:
- The compressor is switched off;
Defrosting is never activated;
-
FiL Air filter check alarm
Solutions:
- Check the filter cleanliness on the display
(to remove the alarm message press any
button)
UtL Fan faulty likely
Solutions:
- See parameters: SP10 and C14
- Check the state of the fan
Main consequences:
- The compressor and fan are switched off;
The water is heated using the electrical
-
resistor only
DOCUMENT 6328408 65