Restore Factory Settings - Sime ECOMAXI 260 ErP Manuel D'installation, D'utilisation Et D'entretien

To change the day of the week:
 Press and release the
followed by two numbers indicating the
day are shown on the display;
 Press and release the
button within 15 seconds.
To change the time (hours):
 Press and release the
changing the day of the week: "hh"
followed by two number indicating the
time are shown on the display (24-hour
clock);
 Press and release the
button within 15 seconds.
To change the time (minutes):
 Press and release the
changing the time: "nn" followed by two
numbers indicating the minutes are
shown on the display;
Press and release the

button within 15 seconds;
 Press and release the
not touch the display for 15 seconds;
To exit the procedure:
 Press and release the
the temperature under parameter P5 is
shown or do not touch the display for 60
seconds.
 Alternatively:
 Press and release the
To set the appliance to operate
at pre-set times, first the current
day and time must be set.
button: "dd"
button or the
button when
button or the
button when
button or the
button or do
button until
button.
DOCUMENT 6328408
Installation, use and maintenance manual
7.1.3.15 Setting the configuration parameters
To access the procedure:
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no
other advanced procedures running;
 Press and hold the
button for
(password) shows on the display;
 Press and release the
 Press and release the
button within 15 seconds to set "-19"
on the display;
 Press and release the
not touch the display for 15 seconds;
 Press and hold the
button for 4 seconds: the first
parameter "SP1" shows on the display.
To select a parameter:
 Press and release the
button.
To change a parameter:
 Press and release the
 Press the button or the
increase or decrease the value of the
parameter (within 15 seconds);
Press and release the

not touch the display for 15 seconds.
To exit the procedure:
 Press and hold the
button for 4 seconds or do not
touch the display for 60 seconds (any
changes are saved).
Turn the appliance off and back
on again
changes to the parameters.

7.1.3.16 Restore factory settings

To access the procedure:
button and the
4 seconds: "PA"
button;
button or the
button or do
button and the
button or the
button;
button to
button or do
button and the
to implement the
67