Sime ECOMAXI 260 ErP Manuel D'installation, D'utilisation Et D'entretien page 62

Installation, use and maintenance manual
If the keypad has been locked
(section 7.1.3.3) or an advanced
procedure
appliance cannot be switched
on/off as normal.
Every time
switched on, it first runs a series of
internal checks before starting up
the heat pump. This is shown by a
flashing light on the compressor
. Once
complete
minutes), the light stays on to
show that
active.
7.1.3.2 Changing the operating mode
(AUTOMATIC, ECONOMY and
OVERBOOST)
7.1.3.2.1 AUTOMATIC mode
To manually start AUTOMATIC mode, do as
follows:
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no
advanced procedures running;
 Press the button and hold for 1
second, the flashing code "Auto" then
appears;
 Then press the
confirm and start AUTOMATIC mode.
To exit the procedure:
 Press the button to exit without
changing the operating mode.
7.1.3.2.2 ECO (economy) mode
To manually start ECO mode, do as follows:
62
is running, the
the appliance is
the checks are
(approximately 5
the appliance is
button again to
DOCUMENT 6328408
 Make sure that the keypad is not locked
(section 7.1.3.3), that there are no
advanced procedures running and that
the appliance is not in OVERBOOST
mode;
 Press the button and hold for 1
second, the flashing code "ECO" then
appears;
 Then press the
confirm and start ECONOMY mode.
To exit the procedure:
 Press the button to exit without
changing the operating mode.
7.1.3.2.3 OVERBOOST mode
To manually start OVERBOOSTmode, do as
follows:
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no
other advanced procedures running;
 Press the button and hold for 1
second, the flashing code "Eco" or
"Auto" then appears;
 Press the or
multiple times until the flashing code
"ObSt" appears on the display;
 Then press the
confirm and start OVERBOOST mode.
To exit the procedure:
 Press the button to exit without
changing the operating mode.
7.1.3.3 Locking/releasing the keypad
To lock the keypad, do as follows:
 Ensure that there is no other advanced
procedure running;
Press and hold the

button for 1 second: "Loc" shows on
the display for 1 second.
If the keypad is locked, no operation can be
performed on the display interface.
button again to
buttons once or
button again to
button and the