Sime ECOMAXI 260 ErP Manuel D'installation, D'utilisation Et D'entretien page 63

If you press any button, "Loc" is
shown on
second.
To release the keypad:
 Press and hold the
button for 1 second: "UnL" shows on
the display for 1 second.
7.1.3.4 Setting the temperature in ECO
mode (SP1)
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no
other advanced procedures running;
 Press and release the
shows on the display;
 Press and release the
compressor LED
 Press and release the
button within 15 seconds. Please
also see parameters r3, r4 and r5;
 Press and release the
not operate the appliance
seconds: the compressor
switches off;
 Press and release the
To exit the procedure before completion:
 Do not touch the display for 15 seconds
(any changes are saved).
7.1.3.5 Setting the temperature in Automatic
mode (SP2)
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no
other advanced procedures running;
 Press and release the
shows on the display;
 Press and release the
button until you see "SP2";
 Press and release the
compressor LED flashes;
 Press and release the
button within 15 seconds. Please
also see parameters r1, r2 and r5;
the screen for 1
button and the
button: "SP1"
button: the
flashes;
button or the
button or do
for 15
LED
button.
button: "SP1"
button or the
button: the
button or the
DOCUMENT 6328408
Installation, use and maintenance manual
 Press and release the
not operate the appliance
seconds: the compressor
switches off;
 Press and release the
To exit the procedure before completion:
 Do not touch the display for 15 seconds
(any changes are saved).
7.1.3.6 Setting the time brackets for
switching the appliance on and off
NOTE: before
automatic operation at pre-set
times, set the current day and
time by following the procedure
in section 7.1.3.14.
To access the procedure:
 Make sure that the keypad is not locked
and that there are no other advanced
procedures running;
 Press and release the
shows on the display.
To set the first time bracket:
 Press and release the
button within 15 seconds to select
"HOn1" (first ON time) and/or "HOf1"
(first OFF time);
"HOF2" for the second ON/OFF;
 Press and release the
 Press and release the
button within 15 seconds;
 Press and release the
not touch the display for 15 seconds.
To associate a time bracket with a day of
the week:
 Following on from the previous point,
press and release the
button within 15 seconds to select
"Hd1" (ON time for day 1/Monday)
and/or "Hd2...7" (ON time for days 2-
7/Tuesday-Sunday);
button or do
for 15
LED ( )
button.
activating
button: "SP1"
button or the
select"HOn2" and
button;
button or the
button or do
button or the
63