Log Placement; Glowing Embers - Napoleon Park Avenue GD82NT-PAE Manuel D'installation Et D'opération

finishing
EN
6.5

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
The individual logs can be easily identified by the numbers cast on the underside of each log. Phazer
glowing embers exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect that is different in every
installation. Take time to carefully position the glowing embers for a maximum glowing effect. During the initial
use of the appliance,
uniform as colour pigments burn in during the heat activated curing process.
note:
Decorative brick panels must be installed before the logs. See installation instructions supplied with the panel kit.
A
Place the rear log #1 onto
A.
the locating studs along
the back edge of the
PHAZERAMIC™ burner.
D. Place log #4 with the
charred branch facing
inward. Position the pin
in log #4 into the hole on
the right of log #2.
6.6

glowing embers

Glowing embers are NOT recommended. The burner has been designed to achieve maximum glow without em-
bers.
36
W415-2358 / B / 05.17.22
log colours may vary. During the initial use of the appliance the colours will become more
B.
D
E. Place log #5 so the
locating hole on the
bottom of the log sits on
the screw and spacer.
B
Position log #2 in the 2
locating holes behind the
andirons.
E
logs and
TM
48.1
C
C. Place log #3, with the
charred branch facing
inward. Position the pin
in log #3 into the hole
on the left of the log #2.
F
F. Finally, align the
rectangular peg on log
#6 with the notch on the
front right portion of the
burner.