Minimum Clearance To Combustibles - Napoleon Park Avenue GD82NT-PAE Manuel D'installation Et D'opération

framing
EN
5.1

minimum clearance to combustibles

Maintain these minimum clearances to combustibles from appliance and vent surfaces
Non-combustible appliance finishing:
- 4" (102mm) from the sides of the appliance opening
- 22 3/8" (568mm) to the top of the appliance opening
Combustible appliance finishing:
- 0" (0mm) to rear
- 2" (51mm) all around the vent pipe*
- 22 1/2" (572mm) recessed depth
- 64" (1626mm) from the bottom of the appliance to the ceiling
- 72" (1829mm) from bottom of appliance to the enclosure top
*HORIZONTAL VENT SECTIONS: A minimum clearance of 2" (51mm) all around the vent pipe on all horizontal runs to
combustibles is required.
*VERTICAL VENT SECTIONS: A minimum of 1" (25mm) all around the vent pipe on all vertical runs to combustibles is
required except for clearances in appliance enclosures.
WARNING
!
• Minimum clearance to combustibles must be maintained or a serious fire hazard could result.
• When constructing the enclosure, allow for finishing thickness to maintain clearances. Framing or finishing
material closer than the minimums listed must be constructed entirely of non-combustible materials. Materials
consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or any combination thereof are
suitable. Materials that are reported as passing ASTM E136, standard test method for behaviour of materials in
a vertical tube furnace at 750°C and UL763 shall be considered non-combustible materials.
• Never obstruct the front opening of the appliance.
1"
25mm
MIN
44"
1118mm
1"
25mm
MIN
22 1/2"
572mm
29" 737mm
28
W415-2358 / B / 05.17.22
10"
254mm
MIN
1"
25mm
MIN
44"
1118mm
1"
25mm
MIN
22 1/2"
572mm
29" 737mm
10"
254mm
MIN