Operation; General Transmitter Layout; Appliance Operation - Napoleon Park Avenue GD82NT-PAE Manuel D'installation Et D'opération

WARNING
!
• If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal
injury, or loss of life.
• Always light the pilot whether for the first time or if the gas supply has run out with the glass door opened or
removed.
8.1

general transmitter layout

8.2

appliance operation

A. Install 4 AA batteries into the receiver battery bay as indicated on the battery cover (+/-). (Only required as
back up to household electricity).
note:
Do NOT connect this appliance to a 9V battery, the connection provided with this appliance should only be
used to connect the 6V battery pack, supplied.
B. Place the 3 position slider switch of the receiver in the "Remote" position.
C. To synchronize the receiver to the transmitter, insert the end of a paper clip, or other similar object into the
hole marked "PRG" on the receiver front cover. The receiver will "beep" three (3) times to indicate that it is
ready to synchronize with the transmitter.
D. Install the 3 AAA batteries in the transmitter battery bay, located on the base of the transmitter. With
the batteries installed in the transmitter, push the "ON" button. The receiver will "beep" four (4) times to
indicate the transmitter's command is accepted and set to the particular code of that transmitter. The
system is now initialized.
TRANSMISSION
CHILD SAFETY
LOCK OUT
TEMPERATURE
LOW BATTERY
ALARM
6
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME FAN AUX. OUTPUT

8.0 operation

ROOM
23.1
W415-2358 / B / 05.17.22
EN
39