5.0 FINISHING
5.1
LOG PLACEMENT
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
PHAZER
logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that
TM
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
PORT CAVITY
A.
Place the rear log (W135-0668) onto the
locating pins along the back edge of the
PORT CAVITY
burner.
C.
Place the end of the crossover log
(W135-0672) on the right side of the knot of
log A. The "Y" in the log should straddle the
knot on top of log B.
PINS
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PINS
A
PINS
C
A
B
WARNING
!
PORT CAVITY
PORT CAVITY
B.
Position the middle log (W135-0669) onto
the locator pins on the burner. Ensure the
port cavity on the underside of the log is
positioned such that it runs over the ports
allowing them to be exposed.
D
PINS
PINS
D.
Place one pin into the left side of log A and
one into the left side of log B. Place the left
side log (W135-0671) onto the pins located in
the left side of logs A and B.
PINS
76.1A
PINS
5
A
5
B
C
A
B
W415-2164 / D / 08.23.18
13
EN