Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.2
log placement
WARNING
!
•
Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
•
Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
•
The logs are fragile and should be handled with care.
In order to install the log set, the glass door must be removed (see "safety barrier and glass door" section in the
GD19N/P-2 manual).
A.
Place the rear log as shown, ensuring the
holes on the underside are placed onto the 2
pins of the log support.
C.
Place the center log as shown, ensuring the
holes on the underside are placed onto the
two centre pins.
BRACKET
B.
D.
E.
Place the left log as shown, ensuring the hole
on the underside is placed onto the burner pin.
This will rest on the left side of the rear log.
Place the hole in the underside of the right log
onto the locating pin on the burner base and
rest it against the rear log as shown.
Re-install the glass door.
installation
EN
3
W415-2781 / 10.09.19
Publicité
Chapitres
Table des Matières
