Log Placement - Napoleon GL18NE Instructions D'installation Et D'utilisation

4.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
Phazer logs, exclusive to Napoleon, provide a unique and realistic glowing effect that is different in every
TM
installation. Failure to follow these log placement instructions may cause sooting.
A.
Place the rear log #1 onto
the locating studs on the
rear log support.
D.
Position the pins on the
bottom of log #4 into the
holes on the left end of
log #1 and the left end
of log #2.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
Positioning the logs improperly will cause flame impingement and carboning.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. Use only
certified Phazer
TM
DAMAGE OR PERSONAL INJURY.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
B.
E.
logs available from your authorized dealer/distributor.
WARNING
!
IGNITION MAY OCCUR.
Position the holes on
the bottom of log #2
onto the fibre embosses
shown.
Place the end of log
#5 on the right end
of log #1. The fork
in the log should
straddle the knot
on top of the log #2.
76.1A
C.
Position the bottom cavity
of log #3 onto the bracket
located in the front right
corner.
W415-1071 / D / 08.08.16
9