Log Placement - Napoleon GDS50N Manuel D'instructions

32
5.3

LOG PLACEMENT

5.3 LOG PLACEMENT
EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
A. Place the 2 piece charcoal ember strip along
the edge of the  rebox
C. Align the square peg on log #2 with the notch
on the base log..
#4
E. Finally, align the square peg on log #4 with
the notch on the left end of the base log.
W415-1427 / 12.23.14
DAMAGE OR PERSONAL INJURY.
DAMAGE OR PERSONAL INJURY.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
LOG SUPPORTS
#2
WARNING
WARNING
!
!
IGNITION MAY OCCUR.
IGNITION MAY OCCUR.
B. Place the base log #1 between the log sup-
ports, ensuring that it is pushed back against the back
of the supports.
D. Align the square pegs on log #3 with the
notches on the right end of the base log.
33
76.1A
#1
#3
W415-1427 / B / 08.01.18
EN