Burner And Valve Replacement; Spark Module Battery Installation - Napoleon Park Avenue GD82NT-PAE Manuel D'installation Et D'opération

11.1

burner and valve replacement

Remove safety screen, refer to "SAFETY SCREEN
A.
REMOVAL / INSTALLATION" section.
Optional Front Removal.
B.
Pull on the top of the optional front away from
the appliance until the male portion of the latch
disengages. Tilt forward slightly and lift from the 4
shoulder screws (if installed).
Control Panel Removal
C.
Tilt control panel away from the door and lift from
slots.
Turn Power and Gas off to the appliance.
D.
Door Removal. See "DOOR REMOVAL" section.
E.
Burner Removal
F.
Start by removing the logs being careful since the logs
may still be warm. Remove the 2 screws holding the
air deflector then remove the 3 screws holding the
burner. Lift burner from firebox.
Remove the 5 screws securing the burner base. Once the gas has been disconnected, the valve train
G.
assembly will lift out. Service components as required.
11.2

spark module battery installation

Remove optional front, see "AFK82/RFK82
A.
FACING KIT INSTALLATION" section.
Tilt the control panel forward and remove
B.
allowing access to the electrode box which is
screwed to the base of the firebox.
Pull back on the battery compartment door
C.
latch and remove.
Install battery.
D.
Reinstall battery compartment and control
E.
doors.
maintenance
AIR
DEFLECTOR
BURNER
W415-2358 / B / 05.17.22
EN
47