Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION—VENTED TO THE OUTSIDE
9
INSTALL DUCT COVERS
■ P lace the decorative duct
covers on top of the hood.
NOTE: The inside (upper) duct
piece has holes on one end.
The holes are intended for use
when the hood is installed for
recirculating purposes. Slide the
inside end into the outer piece;
the vent holes should not be
visible in this installation.
The inside duct piece must slip into the folded ends of
the outer section.
Upper
duct cover
Lower duct
cover
Lower duct
cover seat
■ E xtend the inner duct upward to the ceiling bracket.
■ S ecure duct cover to ceiling bracket with 2 screws.
14
Installation Instructions
Mounting
screws
Duct cover support
bracket
Duct cover
support bracket
10
INSTALL FILTERS
IMPORTANT:
Check to be sure that the main ON/
OFF switch next to the motor is in the ON position.
■ R emove protective film on the filters.
Filter Lock
■ T ip the filter into the left or right side of the opening.
Lift the filter to the opposite side and into the filter
lock.
■ T o remove the filter, pull the filter lock downward.
11
FINALIZE INSTALLATION
■ C heck to be sure all tape and packaging materials
have been removed.
■ R efer to the Owner's Manual for operating
instructions.
1" = 2.5 cm; 1' = 0.3 m
49-80328 Rev. 4
Publicité
Table des Matières
