Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION—RECIRCULATING
4
PREPARE THE HOOD
■ P lace the hood on a padded surface.
■ P osition the motor housing at the back of the hood.
Electrical connectors should face the front, with rear
mounting hooks at the back.
■ S lip the bottom flange of the motor housing into the
side slots at the top rear opening.
Rear view
Engage flange on
motor housing into slots
■ C arefully lay the hood on its back.
■ F asten the hood to the motor housing from the
bottom, using 6 screws.
Front side
Bottom view
Rear side
■ J oin two cable connectors at the front of the hood.
1" = 2.5 cm; 1' = 0.3 m
49-80328 Rev. 4
Installation Instructions
Rear
mounting
hooks
To Lights
To
Control
Panel
5
MOUNT THE HOOD
WARNING
2 people are required to lift and
position the hood onto the mounting bracket.
■ L ift the hood onto the mounting bracket.
■ P osition a spirit level at the bottom of the hood to
check side to side leveling.
6
LEVEL THE HOOD
This hood has built-in levelers on the mounting hooks
at each side. Use a long Phillips screwdriver from the
front to access the levelers.
Levelers
■ U se the top screw hole in the leveler to raise or
lower the hood on that side.
■ U se the bottom screw hole to pull the hood tight
against the wall surface.
Screw hole
■ M ark hole location at the bottom of the hood.
■ R emove the hood. If the bottom screw hole does
not enter a stud, enlarge the hole to 3/8" and install
wall fastener anchors.
■ P lace the hood back onto the mounting bracket,
check level again and install the wall fastener.
17
Publicité
Table des Matières
