Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure
to use U.L. approved anti-oxidant compound and
aluminum-to-copper connectors.
■ I nsert house wiring through strain relief and tighten.
■ C onnect white leads to branch circuit white lead.
■ C onnect black leads to branch circuit black lead.
■ C onnect green/yellow leads to branch circuit green
lead or bare ground lead.
■ S ecure all connections with wire nuts on each
electrical connector.
■ P ush wires into junction box and replace cover. Be
sure wires are not pinched.
7 INSTALL DUCT COVERS
■ P lace the decorative
duct covers on top
of the hood.
■ I nsert the lower
portion of the duct
cover into the
impressions on the
top of the hood.
■ E xtend the inner
duct upwards to the
ceiling bracket.
■ S ecure the duct cover to the bracket with the 2 small
Phillips screws provided.
1" = 2.5 cm; 1' = 0.3 m
31-14900 Rev. 2
Installation Instructions
Mounting Screws
8 INSTALL FILTERS
■ R emove protective film on the filters.
■ T ip the filter into the slots at the rear of the opening.
Lift the filter and pull the knob forward until the filter
rests on the slots.
■ I nstall all 3 grease filters.
■ T o remove the filters, grasp the knob, push the filter
towards the rear and tilt downwards.
■ I f the Clean Filter Reminder is glowing red after
filters are installed, be sure to check the left side
filter is making contact with the filter switch.
Bottom
Notches
9 FINALIZE INSTALLATION
■ R emove the protective film covering the control
panel on the front face of the hood, and any other
packaging materials.
■ R efer to the Owner's Manual for operating
instructions.
11
Publicité
Chapitres
Table des Matières
