Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION—RECIRCULATING
9
INSTALL DUCT COVERS
■ P lace the decorative duct
covers on top of the hood.
NOTE: The inside piece has
holes on one end intended for
use when the hood is installed for
recirculating purposes. Be sure
the vented end is at the top; the
vent holes will be visible in this
installation.
The inside duct piece must slip
into the folded ends of the outer
section.
Upper
duct cover
Lower
duct cover
Lower duct
cover seat
■ E xtend the inner duct upward to the ceiling bracket.
■ S ecure duct cover to ceiling bracket with 2 screws.
1" = 2.5 cm; 1' = 0.3 m
49-80328 Rev. 4
Installation Instructions
Mounting
screw holes
Vent holes
Duct cover support
bracket
Duct cover
support bracket
10
INSTALL FILTERS
IMPORTANT:
Check to be sure that the main ON/
OFF switch next to the motor is in the ON position.
Charcoal filter
■ I nstall the black charcoal filter into the center
opening. Secure the filter with thumbscrews on
each side.
Metal filter
■ T ip the filter into the left or right side of the opening.
Lift the filter to the opposite side and into the filter
lock.
Filter Lock
11
FINALIZE INSTALLATION
■ R emove all tape and packing material.
■ R efer to the Owner's Manual for operating
instructions.
19
Publicité
Table des Matières
