Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION—VENTED TO THE OUTSIDE
4
PREPARE THE HOOD
■ P lace the hood on a padded surface.
■ P osition the motor housing at the back of the hood.
Electrical connectors should face the front, with rear
mounting hooks at the back.
■ S lip the bottom flange of the motor housing into the
side slots at the top rear opening.
Rear view
Engage flange on
motor housing into
slots
1" = 2.5 cm; 1' = 0.3 m
49-80328 Rev. 4
Installation Instructions
Rear
mounting
hooks
■
Carefully lay the hood on its back.
■ F asten the hood to the motor housing from the bottom,
using 6 screws.
Front side
Bottom view
Rear side
■ J oin two cable connectors at the front of the hood.
To Lights
To
Control
Panel
11
Publicité
Table des Matières
