Tools And Materials Required; Remove The Packaging - Monogram ZV900 Instructions D'installation

TOOLS AND MATERIALS REQUIRED

(NOT SUPPLIED)
■ Tape measure
■ Knife
■ Spirit level
■ Wire cutter/stripper
■ Wire nuts
■ Electric drill with 5/16" and 3/8" bits
■ Phillips and flat blade screwdrivers
■ Hammer
■ Pliers
■ Safety glasses
■ Duct tape
■ Tape to mount template
■ Gloves to protect against sharp edges
■ 1 20V 60Hz. 15 or 20 Amp, 2 wire with
ground Properly grounded branch circuit
■ Strain relief for junction cover
■ 8 " round metal duct, length to suit
installation
■ S aw, jig saw or reciprocating saw

REMOVE THE PACKAGING

CAUTION
LIFT THE HOOD OUT OF THE BOX
BY THE CENTER METAL PORTION. DO NOT LIFT BY
THE GLASS SIDES.
CAUTION
Wear gloves to protect against
sharp edges.
■ G rasp the hood by the metal insert in the center and
lift straight up and out of the box.
■ R emove and properly discard the plastic wrapping.
■ R emove parts box, duct covers and other packaging.
6
Installation Preparation
Measuring tape
756Dia22
Pliers
Duct tape
Strain relief
Strain Relief I
Wire nuts
Spirit level
756Dia19
Electric drill
with 5/16"
and 3/8" Bits
756Dia28
Safety glasses
756Dia24
12" long
Phillips
head
screwdriver
756Dia15
Saw, jig saw or
Masking tape
reciprocating
Gloves
756Dia25
Knife
Wire cutter/
stripper
Hammer
Wire Cutter/Strippe
Flat blade
screwdriver
8" round metal
saw
duct, length to suit
installation
1" = 2.5 cm; 1' = 0.3 m
49-80328 Rev. 4