Glass Canopy; Stainless Steel Hood Surfaces; Light Bulbs - Monogram ZV900 Manuel De L'utilisateur

CARE AND CLEANING

GLASS CANOPY

Clean with a damp, soapy cloth and dry with a clean cloth.
A glass cleaner may also be used.

STAINLESS STEEL HOOD SURFACES

Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.

LIGHT BULBS

To change the light bulbs:
1. Remove the inner lamp lens cover by inserting a small
flat blade screwdriver into each of the three slots and
gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
2. Grasp the bulb and pull it straight out.
3. Replace with the same wattage, type and size bulb.
Wear Gloves. Do not touch bulb with your bare fingers.
These 12 volt, 20 watt halogen bulbs with a G4 base
are available at specialty lighting stores and home
building centers.
NOTE: If WRONG WATT BULB appears in the display,
the wrong kind of replacement bulb has been used.
Replace with the same wattage, type and size bulb as
the one removed.
4. Replace inner cover by inserting the three retaining tabs
into the three slots and pressing them firmly in place.
49-80403 Rev. 6
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer nearest
you, visit monogram.com
Use a small flat blade screwdriver to
remove the inner lamp lens cover.
Bulb
NOTE: Make sure the tabs are inserted into the slots.
Outer trim ring
(lamp assembly)
Do not remove
Removable inner
lamp lens cover
7