Stainless Steel Hood Surfaces; Light Bulbs - Monogram ZVC48LSS Manuel Du Propriétaire

Do not use a steel wool pad; it will scratch
Stainless
the surface.
steel hood
To clean the stainless steel surface, use warm
surfaces
sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To change the light bulbs:

Light bulbs

1. Grasp the outer trim ring and twist until
2. Grasp the bulb and twist until reaching the
3. Replace with the same wattage, type and
4. Replace the outer trim ring by inserting the
8
reaching the unlock position. Then pull the
ring straight out.
unlock position. Then gently pull the bulb
straight out.
size bulb. Wear gloves. Do not touch bulb
with your bare fingers.
These 120 volt, 50 watt halogen bulbs with a
GU10 base are available at specialty lighting
stores and home building centers.
two retaining tabs into the two tab slots,
pressing the ring flush with the surface of
the hood insert and twisting until reaching
the lock position.
Care and Cleaning
Custom Hood Insert
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number:
Monogram Preferred Service: 800.444.1845
Monogram.com
49-80565-5